Skip to main content
Skip table of contents

Power on the Appliance.

Your new NetMon appliance is equipped with a redundant power supply configuration, which consists of two individual hot-swap components. For hot-swapping to occur, each of the two power supplies must be powered with its own cord. NetMon appliances equipped with non-redundant power supplies will only require one power cord. LogRhythm recommends also using a fault-tolerant power source, such as an Uninterrupted Power Supply (UPS).

  1. Connect the power cables.

  2. Bend the system power cable into a loop, then secure the cable in the provided strap.

  3. Plug the other end of the cables into a grounded electrical outlet or a separate power source, such as a UPS or a Power Distribution Unit (PDU).

  4. Turn on the system by pressing the power button. The power indicators light up

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.