Skip to main content
Skip table of contents

Connect System Monitor Agents to Existing Data Processors

To reconfigure the Agent to connect to a different Data Processor that is already configured (it may previously have been a secondary, failover Mediator, etc.):

  1. On the main toolbar, click Deployment Manager.
  2. Click the System Monitors tab.
  3. Select the Agent that is going to switch Data Processors.
  4. Right-click the selection, and then click Properties.
    The System Monitor Agent Properties window appears.
  5. Click the Data Processor Settings tab.
  6. Select the Data Processor to which the Agent will connect.
  7. Click the up arrow next to Change Priority.
  8. Click OK.
  9. On the Restart Component dialog box, click OK.
  10. Check the Action check box for the Agent which was just modified.
  11. Right-click the selection, click Actions, and then click Service Restart.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.