Skip to main content
Skip table of contents

Modify Log Distribution Service Properties in Data Processors

 In the Data Processors Advanced Properties window, you can modify the LDSEngineQueueSize and LDSDistributionQueueSize values.

To modify these properties:

  1. On the main toolbar, click Deployment Manager.
  2. Click the Data Processors tab.

  3. Double-click the Host Entity you want.
    The Data Processor Properties window appears.

  4. In the lower-left corner, click Advanced.
    The Data Processor Advanced Properties window appears.

  5. Locate the following properties in the Mediator component and make the necessary changes.

    PropertyDefault ValueMinimum ValueMaximum ValueDescription
    LDSEngineQueueSize600001000500000Specify the size of the primary log distribution queue. If you exceed the queue size, all additional logs sent to the LDS Engine Queue will be dropped.
    LDSDistributionQueueSize100001000100000Specify the size for each log distribution queue. Every receiver has its own queue. If you exceed the queue size, all additional logs sent to the LDS Receiver Distribution Queue are dropped. If the value is set too high, you could potentially see excessive memory utilization. A log message will be written to ldsengine.log if the queue size is approaching the LDSDistributionEngineQueueSize value.
  6. Click OK.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.